4/19/2023 0 Comments Tiled hot tub![]() ![]() The roof was made in pretty much the same way as the walls, e.g. We also took this opportunity to run some low voltage lighting before we added the insulation and inner panels. We wanted a double-glazed rooflight window in our hot tub room's roof to allow in as much natural light as possible, so the frame was built with this in mind. Since we wanted the room to be as sound-proof as possible, we filled the wall cavities with polystyrene insulation. A timber frame was then erected for both the walls and roof, and on to this we cladded the walls (both sides) with tongue and groove pine. We also put a DPC (damp proof course) on top of the bricks. This course of bricks would stop any water penetration into the base of the timber, and keep any spilled water inside the tub area. It would also act as a strengthening ring to counter the water pressure inside.Ī course of engineering bricks was laid on the concrete base to support the timber enclosure that we were about to build. This was filled with concrete to provide a floor around the outside of the hot tub. We then shuttered around the tub in line with our existing summer house structure to a thickness of approximately 150mm. Ignore the gaps you can see in the photos at the base of the tub walls, as originally we thought we would need them for the drainage pipework, but we did it differently in the end. The inner walls were 2 courses of thermalite bricks high, and these would act as the base for the seat. The main outer walls of the tub consisted of 4 courses of thermalite blocks followed by one course of regular bricks (we used regular bricks to bring us closer to our target height). ![]() After the concrete had set (the next day) we began to build the outer wall. Once the hole was dug, we laid a plastic membrane in it, and filled it with 150mm of concrete. We worked this out from the desired inner desired dimensions plus 2 widths of thermalite blocks (100mm) on both the width and length. This measured 2200mm long x 1700mm wide x 500mm deep. Prepare the baseįirst we dug a hole in the ground. We decided that we wanted to build an enclosure around the tub so that we could use it in all weathers / seasons. Also it was the furthest point from any of our neighbours' houses, which would minimise the noise levels for them. The build site was chosen because it had the best view of the whole garden. Here you can read the steps we took from start to finish. There are many different ways you could construct a hot tub, but we decided to use a breeze block structure, which was then screeded tiled. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |